Video Description
Follow this quick video and step-by-step checklist to install Bali cordless natural (woven wood) shades with an inside mount. You’ll place and level brackets, snap the headrail into place, attach handles, and run a smooth first operation—no lift cords required.
Good to know: Inside mounts deliver a clean, built-in look. If your frame is slightly out of square or you need maximum darkness, consider an outside mount for added overlap.
What’s in the Box (Typical)
- Headrail with natural/woven wood shade pre-attached
- Inside-mount brackets (left/right) + center support for wider shades
- Mounting screws
- Cordless handles (attach to bottom rail; some models include a mid-rail handle)
Tools You’ll Need
- Tape measure, pencil, level, step stool
- Drill/driver with 1/8" (3 mm) bit, Phillips screwdriver
- Wall anchors if not fastening into wood
- Safety glasses
Before You Start
- Depth check: Verify minimum recess depth for your cassette/headrail (see your product sheet).
- Dry-fit: Hold the headrail in the opening to confirm clearance around locks/trim.
- Bracket plan: Mark bracket positions so faces are co-planar (same height and plane) for a smooth snap-in.
Inside Mount — Step-by-Step
- Mark & pre-drill: With the headrail centered in the opening, mark bracket locations flush and level. Depending on your mounting surface, you may need to pre-drill pilot holes.
- Install brackets: Fasten left/right brackets and any center support. Keep bracket faces aligned on a single plane.
- Attach the headrail: Place the headrail onto the bolts on the bracket and attach the wingnuts and tighten.
- Attach handles: Clip the handle at the center of the bottom rail (and mid-rail handle if included) for even operation.
First Run & Leveling
- Lift and lower from the center of the bottom rail using two hands for level travel.
- If one side rides higher, re-seat the headrail (ensure every bracket is locked) and cycle the shade fully up/down 2–3 times to balance internal tension.
Light & Privacy Tips
- Inside mounts may show small side light gaps—normal for shades. Layer drapery or consider an outside mount for more coverage.
- Because woven wood fabrics do not always provide complete privacy, we recommend adding a privacy liner. If you want more light control, then upgrade to a blackout liner.
- For door mounts, optional hold-down brackets (if available for your model) can reduce sway.
Care & Cleaning
- Dust with a microfiber duster or vacuum gently with a brush attachment.
- Spot-clean sparingly with mild soap and water; avoid harsh chemicals to protect natural fibers.
Troubleshooting
- Shade looks tilted: Confirm all wingnuts are fully tightened and the headrail is level; cycle fully to equalize.
- Fabric rubs trim: Slide bracket positions slightly forward/back or consider an outside mount for added clearance.
Still deciding on textures or opacity? Request free swatches to compare natural weaves in bamboo shades in your lighting.
Installation FAQs — Bali Cordless Natural Shades (Inside Mount)
What’s the minimum depth for an inside mount?
Minimum recess depth varies by headrail style. Check your product sheet; if depth is limited, a partial recess will work but the headrail may project slightly beyond the frame.
Why does the shade lift unevenly after install?
Operate from the center with two hands and cycle the shade fully up/down a few times to balance internal tension. Also confirm all brackets are locked and the handle is centered on the rail.
Can I add a valance, liner or edge binding later?
No, the Bali models ship with a valance, but it is not possible to add edge binding or liners afterwards.
Need more choices? Shop our entire line of top Bali window treatments
